Autocut Monthly Maintenance

This page contains changes which are not marked for translation.

Author avatarGareth Green | Last edit 23/10/2019 by Gareth Green being drafted

  • Prerequisites tutorials

Step 2 - Clean and Lubricate the Pusher Chain

Lubricate the chain every 500mm with a drop of oil - use a wire brush to really give a good clean at the same time.

Step 3 - Lubricate Saw Lift Bearings

There are 4 grease nipples on the main saw blade assembly - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Step 4 - Open the saw access hatch

This is the hatch below the eject table area - there is 4 x M6 bolts to take out

Step 5 - Lubricate Eject bearings

There are 4 grease nipples under eject - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Step 6 - Check Saw Blade

Tutorial for Saw Blade change:

https://stuga.dokit.app/wiki/Changing_Main_Saw_Blade

Step 7 - Check Saw Belts

Change the saw belts if they are showing signs of wear or fraying

Comments

Draft