This category uses the form Tutorial.

Last discussionsAsk a question

0 Answer(s)
Datum Spindle is a Spindle with a 10mm Tool fitted .
Gareth Green
Jul 9 at 11:00 am

0 Answer(s)
On the original FDS Zeb files the label format is for 102mm Width to get the new printers to work you need set width at 832 (102mm) and in Advanced settings set left Position at -30 (-3mm) which will allow the label to work on a 99mm width
Gareth Green
Jun 19 at 12:11 pm

0 Answer(s)
Check Clutch Plate Torque Loading- Still to follow. The Steel Plates fitted all together as C cup Plates is the setting for Maximum load required to Make the Torque Limiter Slip.
Gareth Green
Feb 22 at 6:38 pm

0 Answer(s)
The sensor gap should also be checked after installation. The maximum Gap to operate is upto 4mm. ideally the sensor should be setup to read closer than this - about 1mm all the way along the Striking plate. A2029 sensor was fitted right on the edge of the 4mm range, and If john gently wobbled the sensor it went on and off. Now lowered
Gareth Green
Dec 5 at 12:44 pm

0 Answer(s)
All Zx5 machines can do this with the any version of software
Gareth Green
Oct 6 at 11:51 am

1 Answer(s)
470,InF_EjPushH,0,OuF_EjectPush,False,40,3,Eject Push Bar Not Home,True,False,2
Gareth Green
Nov 23 at 10:02 am