Autocut Monthly Maintenance

Auteur avatarGareth Green | Dernière modification 23/10/2019 par Gareth Green en cours de rédaction

Pas encore d'image

  • Tutoriels prérequis

Étape 2 - Clean and Lubricate the Pusher Chain

Lubricate the chain every 500mm with a drop of oil - use a wire brush to really give a good clean at the same time.

Étape 3 - Lubricate Saw Lift Bearings

There are 4 grease nipples on the main saw blade assembly - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Étape 4 - Open the saw access hatch

This is the hatch below the eject table area - there is 4 x M6 bolts to take out

Étape 5 - Lubricate Eject bearings

There are 4 grease nipples under eject - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Étape 6 - Check Belts

Commentaires

Draft