DiscussionsPoser une question
0 Réponse(s)
Datum spindle - What tool is it
Datum Spindle is a Spindle with a 10mm Tool fitted .
0 Réponse(s)
On the original FDS Zeb files the label format is for 102mm Width to get the new printers to work you need set width at 832 (102mm) and in Advanced settings set left Position at -30 (-3mm) which will allow the label to work on a 99mm width
0 Réponse(s)
Z082 is a ZX5E - No Beam on GX axis - How many links will it need
0 Réponse(s)
The sensor gap should also be checked after installation. The maximum Gap to operate is upto 4mm.
ideally the sensor should be setup to read closer than this - about 1mm all the way along the Striking plate.
A2029 sensor was fitted right on the edge of the 4mm range, and If john gently wobbled the sensor it went on and off.
Now lowered
0 Réponse(s)
All Zx5 machines can do this with the any version of software
1 Réponse(s)
470,InF_EjPushH,0,OuF_EjectPush,False,40,3,Eject Push Bar Not Home,True,False,2
1 Réponse(s)
Z055 - ZX4 has been fitted using existing Software setup so Ou_InvDP not used (24v linked to S3 and S4.X308 - Inverter Zero fitted but not used. Uses Drive Run Fwd not using SMOT.
Pages dans la catégorie « Maintenance »
Cette catégorie comprend 296 pages, dont les 4 ci-dessous.
(page précédente) (page suivante)