Changes made on Version 1 GB machine to interface with Autoflow Mk4
Sommaire
- 1 End Stop Near Machining Centre
- 2 Datum Flag
- 3 Material Sensor Separation
- 4 Z Axis Rubber End Stop (Bottom)
- 5 Gripper Handing
- 6 Forward Clamp Opening Height (Vorlaufwagen)
- 7 Labelling Pressure Regulators
- 8 Adjusting Flow Control Speeds and Pressures
- 9 Adjust Conveyor Index Position
- 10 Check GY to Backfence Parallelism
- 11 Measuring Sensor Setup
- 12 Table Parameters
- 13 Tuning GY and GZ Motors
End Stop Near Machining Centre
Datum Flag
Material Sensor Separation
Z Axis Rubber End Stop (Bottom)
Gripper Handing
Forward Clamp Opening Height (Vorlaufwagen)
Rotated roller arm on mount to move further away from infeed cylinders
Also required infeed top clamp to move over one hole
Labelling Pressure Regulators
Adjusting Flow Control Speeds and Pressures
IO screen system updated to allow for cyclical control of Solenoid / Solenoid operated valves
See Cyclical Control of Outputs to Aid Cylinder Speed Setup
Adjust Conveyor Index Position
See Stuertz Conveyor Motor and Indexing Setup
Check GY to Backfence Parallelism
See Stuertz Infeed - Check GY Position Parallelism
Measuring Sensor Setup
See Stuertz Infeed - Setting Measuring Sensor
Table Parameters
See Stuertz Infeed Table Measurements
Tuning GY and GZ Motors
See GY GZ axis setup with Jetter Motors
Draft
Français
English
Deutsch
Español
Italiano
Português