Autocut Monthly Maintenance

Carry out these checks once per month alongside daily and weekly checks

Difficulté

Easy Facile

Durée

20 minute(s) minute(s)

autocut, monthly, maintenance

• Pièces et outils
• Tutoriels prérequis

Pièces et outils

Grease Gun

Grease Gun

Grease Gun

Oil Can

M0000200 Oil Can

Oil Can

Wire Brush

Wire Brush

Wire Brush

Tutoriels prérequis

Étape 1 - Open the Guard doors

https://stuga.dokit.app/wiki/Autocut_Open_Guard_Doors

Étape 2 - Clean and Lubricate the Pusher Chain

Lubricate the chain every 500mm with a drop of oil - use a wire brush to really give a good clean at the same time.

Étape 3 - Lubricate Saw Lift Bearings

There are 4 grease nipples on the main saw blade assembly - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Étape 4 - Open the saw access hatch

This is the hatch below the eject table area - there is 4 x M6 bolts to take out

Étape 5 - Lubricate Eject bearings

There are 4 grease nipples under eject - 1 pump of grease is required for each nipple.

...If this is an older machine, the grease nipples may not be fitted. Oil the shafts instead

Étape 6 - Check Belts

en none 0 Draft