WinMulti - Postest

This page will describe how to generate a Postest (operation position test), and is used to set the distance between the ring and the saw blade so that routed pieces line up correctly back to back.

winMulti, Postest, Accuracy, Tests WinMulti_-_Postest_Postest.jpg

Postest

To Produce a Postest perform the steps below

1. 1.Tap on the F7 Service button on the main toolbar
2. 2. This will open the service menu, click on the Tests tab. you will see the screen to the right.
3. 3. Select your profile from the list
4. 4. Select the colour from the Colour Drop Down
5. 5. If you are using an offcut, change the standard bar length to the length of the offcut you wish to use.
6. 6. Tap on the Pos Test Button

This will add 2 450mm pieces with square ends and a datum test in the middle, to the bar queue as below

Bar Queue

Above is a depiction of the bar queue, prep and cut these pieces as normal.

Lining up the Pieces

Lining up the Postest Pieces

Once the postest pieces have been cut they should be put back-to-back as shown to the right

With the holes Lined up the Offset at the ends of the profile should be measured. If prepped on outer frame the bottom piece should have the beadrail toward the tester, and the top piece should have the beadrail away from the tester.

From here click into the Settings menu, on the right there will be 2 possibilities, determine which picture best reflects your pieces (either the top piece is to the left or to the right of the bottom piece) enter the offset into the appropriate box. then click the Save button below.

This will change the appropriate parameter related to your machine. once complete, redo the postest to check that all is now well.

To Return to the main page, please click WinMulti Software Operating Guide en none 0

Draft