| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 20 : | Ligne 20 : | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Removing old Valve Slice</translate> | |Step_Title=<translate>Removing old Valve Slice</translate> | ||
| − | |Step_Content=<translate>When removing the slice be careful not to bend the pins on the slice. | + | |Step_Content=<translate>Pull Valve slice off, holding at the bottom and top of the slice. When removing the slice be careful not to bend the pins on the slice. |
Also make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.</translate> | Also make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.</translate> | ||
Version du 19 septembre 2019 à 16:35
Instructions on how to change a Pneumax valve slice
Difficulté
Facile
Durée
5 minute(s)
Étape 1 - Undo fixing screws using small pozi Screwdriver.
Please ensure screwdriver is a good fit to avoid wearing the bolt head.
Étape 2 - Removing old Valve Slice
Pull Valve slice off, holding at the bottom and top of the slice. When removing the slice be careful not to bend the pins on the slice.
Also make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.
Étape 3 - Fitting New Valve Slice
Ensure pins line up correctly and are carefully inserted. Push valve slice on. When tightening the screws, screw in 2 turns on each of the side until tight to ensure a square fit. Do not over tighten, the bolts will strip easily.
Draft
Français
English
Deutsch
Español
Italiano
Português