Changing Pneumax Valve slice : Différence entre versions

[version en cours de rédaction]

[version en relecture]

Version actuelle datée du 20 septembre 2019 à 09:29

Instructions on how to change a Pneumax valve slice

Difficulté

Facile

Durée

5 minute(s)

Instructions on how to change a Pneumax valve slice

Difficulté

Facile

Durée

5 minute(s)

valve, slice, pneumax, air

Please ensure screwdriver is a good fit to avoid wearing the head of the screw.

Pull Valve slice off, holding at the bottom and top of the slice.

When removing the slice be careful not to bend the pins on the slice.

Make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.

Ensure pins line up correctly and are carefully inserted. Push valve slice into position.

When tightening the screws, screw in 2 turns on each of the side until tight to ensure a square fit.

...Do not over tighten, the bolts will strip easily

en none 0 Published

@@ Ligne 6 : / Ligne 6 : @@
 |Duration=5
 |Duration-type=minute(s)
+|Tags=valve, slice, pneumax, air
 }}
 {{Introduction
 |Introduction=<translate></translate>
 }}
-{{Materials}}
+{{Materials
+|ItemList={{ItemList
+|Item=Small Pozi Head Screwdriver
+}}
+}}
 {{EPI}}
 {{Tuto Step
@@ Ligne 20 : / Ligne 25 : @@
 {{Tuto Step
 |Step_Title=<translate>Removing old Valve Slice</translate>
-|Step_Content=<translate>Pull Valve slice off, holding  at the bottom and top of the slice. When removing the slice be careful not to bend the pins on the slice.
+|Step_Content=<translate>Pull Valve slice off, holding  at the bottom and top of the slice.
-Also make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.</translate>
+{{Warning|When removing the slice be careful not to bend the pins on the slice.}}{{Info|Make sure the Valve Gasket piece does not fall out or go missing. This is needed to stop leaks.}}<br /></translate>
 |Step_Picture_00=Changing_Pneumax_Valve_slice_IMG_2483.jpg
 |Step_Picture_01=Changing_Pneumax_Valve_slice_IMG_2484.jpg
@@ Ligne 50 : / Ligne 55 : @@
 }}
 {{Tuto Status
-|Complete=Draft
+|Complete=Published
 }}