On the original FDS Zeb files the label format is for 102mm Width to get the new printers to work you need set width at 832 (102mm) and in Advanced settings set left Position at -30 (-3mm) which will allow the label to work on a 99mm width
The sensor gap should also be checked after installation. The maximum Gap to operate is upto 4mm.
ideally the sensor should be setup to read closer than this - about 1mm all the way along the Striking plate.
A2029 sensor was fitted right on the edge of the 4mm range, and If john gently wobbled the sensor it went on and off.
Now lowered
Z055 - ZX4 has been fitted using existing Software setup so Ou_InvDP not used (24v linked to S3 and S4.X308 - Inverter Zero fitted but not used. Uses Drive Run Fwd not using SMOT.
Gareth Green
May 2 at 7:01 pm
×
Erreur de saisie dans le nom du tutoriel
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #
Connexion
Pas encore enregistré ? Créez un compte pour profiter de toutes les fonctionnalités du service !
Known Problems