TB0390 Fitting SR Datum Sensor

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 14/03/2020 par Gareth Green en cours de rédaction

Introduction


Item Number Part Number Description Qty
1 D0015489 Saw Turntable Sensor Bar 1
2 D0015490 Saw Turntable Sensor Flag 1
3 D0015491 Saw Turntable Flag Bracket 1
4 E0000336 8mm Threaded Proximity Sensor 1
5 E0000337 M8 90° Lead 1
6 F0000543 U Bolt 3” with Nuts 1
8 F0000059 M8 Washer 2
9 F0000014 M6 x 20 SKT CAP SCREW 2
10 F0000028 M8 x 50 SKT CAP SCREW 2

Étape 1 - Fit U Bolt and Sensor Bar

Fit U Bolt and Sensor Bar to Table Post on infeed side of saw. See Image for height



Étape 2 - Remove 2x M8 screws

Remove 2x M8 screws holding Motor Plate.

Étape 3 - Fit Flag and Bracket to Motor Plate with 2x M8 x 50 Screws

Fit Flag and Bracket to Motor Plate with 2x M8 x 50 Screws

Étape 4 - Ensure Bracket is far right in the slots

Ensure Bracket is far right in the slots and sensor flag is parallel to turntable base.

Étape 5 - Check sensor is activated

Check sensor is activated by the flag and stays on when turntable is in maximum position

Étape 6 - ELECTRICAL

Sensor wiring should be

Cable Colour IO Terminal X06
Brown 24v
Blue 0v
Black 0



Étape 7 - SOFTWARE SETUP

Drive must be set up to map IO values through to Drive_IO_Status[Axis] array. This is done in 2 steps

1.      Add the Digital Inputs State PDO P-0-0801 to S-0-0016 for the SR drive. If a dual axis drive used, ensure you select the correct PDO from the PDO List as there is one for each axis. This is all in the Process Data tab.

2.      Link the Digital inputs word to to Drive_IO_Status[9] – simply double click it in the list of IO for the drive



Commentaires

Draft