Setting up DatumToMat, DatumToSaw and LaserToSaw on ZX Machines with lasers fitted

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 27/09/2022 par Gareth Green en cours de rédaction

Pas encore d'image

Zx3/Zx4 - Setting up DatumToMat, DatumToSaw and LaserToSaw

Difficulté
Facile
Durée
20 minute(s)

Introduction

DatumToMat

It is very important after fitting a servo motor, Pinion gear or new Journals to set up the DatumToMat before setting the DatumToSaw.


What is the Datum to mat --- its this position of where the saw pusher stops when a bar is loaded in to the saw from the transfer table.

  1. Initialise the machine


Look to see where the end of the Saw Pusher is Compared to the End Buffer beam on the transfer table.


Datumtomat.jpg


This is how it should look, InLine or just behind


Étape 1 -

Commentaires

Draft