Ecoline Site Installation Guide

How to install a Stuga Ecoline

Difficulté

Medium Moyen

Durée

4 hour(s) heure(s)

Ecoline_Site_Installation_Guide_Media_6-5409E17B-E436-4433-9DEC-337B536C4920.jpg

Introduction

Installation of an Ecoline is quite straight-forward as all of the main levelling and alignment is taken care of inside the main module housing.

Installation involves 3 steps

1. Levelling main module
2. Attaching and Levelling Infeed Frame
3. Refitting Infeed cover

Vimeo

Étape 1 - Forklift machine

...The lifting balance point is not the centre of the machine - the centre of gravity is towards the maching head end

...The machine weight is 2t, so an appropriate forklift is necessary

Étape 2 - Ensure services are in place

Services Required

• Electrical - 16A 3ph + Neutral. The machine is supplied with a 32A Quick-Connect Socket
• Pneumatic - 10cfm 6 bar
• Network - Cat5e with internet access

...These services are vital for installation

Étape 3 - Floor area

...Ensure the floor area is level and clean of dirt and debris

Étape 4 - Health and Safety Checklist

• Inform all personell in area that an installation is going on
• Lift and move the machine with 2 pallet trucks, rated capacity 2t
• 2 man lift is required to fit the infeed guard

Étape 5 - Machine Placing

Allow adequate room around the machine for electrical door access

Étape 6 - Plastic Feet

The machine is supplied with plastic feed for the machine levelling bolts to sit on

Étape 7 - Level Main Frame

Étape 8 - Pull infeed into place

Ensure the pegs do not interfere with slots when they are at their 90 degree position, and that the table is not inserted "too deep" so the pegs bottom out

...The photo here shows the infeed table position before it is pushed back to its correct position

Étape 9 - Level Infeed

Machine should be levelled to within 1mm in 1000mm

Étape 10 - Ensure Roller Height clears Plastic

This is what the taper on the roller approach is for - to raise the profile onto the rollers

Étape 11 - Connect the infeed connections

• Air Pipes
• Material Load Sensor
• Barcode Reader

Étape 12 - Ensure the top guard clears the infeed pull / grip assembly

en none 0 Draft