Common Issue - Mitre Cuts Cutting Short

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 3/03/2020 par Gareth Green en cours de rédaction

Common Issue - Mitre Cuts Cutting Short 2020-03-03 09.22.01.jpg

If the length of pieces with mitred ends are too short from the saw, there are some simple root causes to check

Sommaire

...The profile needs to be pushed up to the rear fence to cut accurately. If anything is preventing this happening, the cuts will be incorrect


The most common faults when frame is being cut short is  
There is a Z block on the rear fences sticking out because of a swarf build up behind it
Common Issue - Mitre Cuts Cutting Short 2020-03-03 09.19.05.jpg
The side fences are not pushing the profile all the way to the rear fences
Common Issue - Mitre Cuts Cutting Short 2020-03-03 09.19.46.jpg
The centraliser mechanism is not all the way back because an offcut is trapped stopping the movement
Common Issue - Mitre Cuts Cutting Short 2020-03-03 09.22.01.jpg
The saw infeed is stopping the profile being correctly positioned on the rear fences.


Commentaires

Draft