Hikvision Camera Setup

Setting up the Hikvision cameras and recording system

Difficulté

Medium Moyen

Durée

10 minute(s) minute(s)

camera, recording Hikvision_Camera_Setup_Annotation_2019-09-04_100923.JPG

Introduction

These are the Hikvision DS-2CD2343G0-I Cameras (C0001152) that will replace the obsolete UCAMs that have been used on previous machines.

Connected via a multi way PoE injector (C0001238).

And with SD card (C0001239).

• Pièces et outils

Pièces et outils

C0001239 Toshiba 32GB SD Card

SD card used in the Hikvision Cameras

C0001239 Toshiba 32GB SD Card

C0001238 Tenda TEF1105P 5 Port PoE Switch

POE Ethernet switch used for the Hikvision cameras

C0001238 Tenda TEF1105P 5 Port PoE Switch

Étape 1 - Open SADPTool

On the machine open the “SADPTool” . This is our camera finder and IP address modifier for the cameras

Étape 2 - Activate Camera

When open, the SADP Tool will display all Hikvision cameras connected to the local network. If the IP address has not been modified before going to site the camera needs to be Activated,.

1. To do this select the current inactive camera.
2. Then open the side sub menu on the far right.
3. Input the password: Stuga001 and click Activate.

Étape 3 - Security Questions

Security Question 1:Your Father’s Name?

Answer 1: Flowline

Security Question 2: Your Mother’s Name?

Answer 2: Microline

Security Question 3: Name of your Class Teacher?

Answer 3: Saw

After this, you will be asked to set the ip address in the IP address section.

Étape 4 - Open in Internet Explorer + Download Plugin

1. Using internet explorer type the IP address into the web address bar.
2. Click on the link to download a plugin. When prompted, click Run.

Not Chrome or Microsoft Edge, Hikvision software struggles with these. Using Internet Explorer and downloading is the most compatible way of using the camera.

Étape 5 - Web Browser User Interface

Étape 6 - Setup SD Card Storage

You will now have a live view of the camera on the “Live View” tab.

Other tabs here are: “Playback” – used for viewing video footage recorded to the SD card; “Picture” – Will be unused by us but is used for viewing pictures captured to the SD card; “Configeration” – Where all settings are aultered such as SD card formatting and display labeling. Go to: Configeration > Storage > Storage Management > HDD Management If the SD card has been installed properly a memory store should be displayed in the HDD management window. Select this, then on the top right of the HDD Management click “Format”. Formatting may take up to 2 minuites. After this the SD card is ready to be written too. Press SAVE

Étape 7 - Schedule Settings

On “Schedule Settings” set all the schedule to ’motion’ and make sure enable is ticked. And SAVE!

Étape 8 - Advanced Schedule Settings

Click “Advanced” in the top right of the window. This is where time recorded upon motion detect is selected.

Set this to: Pre-record: 5s

Post-record: 1 minuite(s)

Stream Type: Main Stream(Normal)

Click OK to confirm and SAVE.

Étape 9 - Web Browser User Interface

en none 0 Draft