Commissioning - Z-Block Calibration

Commonly used during sawing on Z transoms, the Z block operation is used to fasten the profile, making sure it does not move during sawing.

Difficulté

Medium Moyen

Durée

30 minute(s) minute(s)

Z-Block, Saw, Commissioning, commission, Z Transom

Introduction

Commonly used during sawing on Z transoms, the Z block operation is used to fasten the profile, making sure it does not move during sawing. There are 6 possible states the z block can be in. Each of these can have a different length of protrusion for different profiles.

12 x M8 Screws

12 x M8 Nuts

12 x wire numbers 1 - 6

Étape 1 - Find First Position on the Turret

On the Service > IO tab use output Y214 and Y215 (ZX5) to turn each of the turrets. Each turn of the turrets will change the binary state of the outputs X210, X220 and X212.

Étape 2 -

en none 0 Draft