Changing Main Saw Blade

How to change the main saw blade on a Stuga machine

Difficulté

Medium Moyen

Durée

10 minute(s) minute(s)

Saw, blade, change

Introduction

Stuga recommends this blade be changed after 2 weeks of cutting - use the following symptoms to determine if the blade

needs changing:

Awful cutting sound / smell

Profile dragging (sizes too short)

Brown burnt swarf

Smoke coming out of profile end while cutting

...The 500mm blade is sharp and can be awkward to manouver out of the saw, please be careful

• Pièces et outils

Pièces et outils

[[Item:|]] A fatal error occurred in the #info parser function

Spanner 24mm

Open ended spanner 24mm

Spanner 24mm

D0005207 Stuga Flange C Spanner

Flange spanner c/w pins for removal of Stuga saw blade

D0005207 Stuga Flange C Spanner

Utiliser des vêtements de protection pour les mains

Avertissement des objets pointus et tranchants

Blessure à la main

Étape 1 - Stop Cutting

Make sure you have stopped cutting and nothing on the machine is moving - press an emergency stop button to ensure this.

Étape 2 - Open the door

Through the winSaw program, press the '[F6] Open Door' button, you may have to wait up to 60 seconds before the guard lock output is on.

Once the timer has finished open the front door (you may have to give the door a slight nudge first

before opening)

Étape 3 - Loosen Blade

Using the saw blade 'C' spanner and the 24mm spanner, loosen and remove the main bolt going through the centre of the saw blade - anti-clockwise to loosen.

Étape 4 - Remove Fastening

Once the bolt is loose; remove the bolt, washer and plate.

...Remember which order they are in, as this is the order they must go back on.

Étape 5 - Remove Blade

Now carefully remove the blade, with this blade being 500mm it will be tight. Ensure you take note of which way the blade spins.

...The blade cutting direction at the top is towards the rear of the machine

Étape 6 - Fit New Blade

Fit the new blade ensuring the teeth are facing the same way it was removed

Étape 7 - Refit Bolt, Plate and Washer

Now fit the plate, washer and bolt ensuring it's tight

Étape 8 - Measure new blade thickness (Kerf)

Measure the thickness of the brand new or sharpened blade - this should be between 3.8mm - 4.1mm

Étape 9 - Update kerf Parameter

Through the winSaw software go into '[F5] Settings' and update the 'Kerf' parameter to what the blade thickness is.

Press 'Save'.

Étape 10 - Close the door

Press '[F10] Reset Saw', now close the main door and ensure it will not open and that the 'Guard' message clears

Étape 11 - Reset Estop

Reset the emergency stop circuit by unlatching emergency stop buttons and pressing the physical blue 'ES RESET' button

en none 0 Draft