Autoflow Maintenance - Sawing Centre

Auteur avatarGareth Green | Dernière modification 8/12/2022 par Gareth Green en cours de rédaction

Introduction

The Machine has many moving parts, all which need regular maintenance. Below outlines what items need particular attention

Étape 1 - Horizontal and Vertical clamps

  • Remove any debris from clamp pads and rollers
  • Visually check the rollers and clamp pads for damage or excessive wear, oil rollers with supplied oil, visually check cylinder rods for damage



Étape 2 - Check Rear Fence Alignment

Using the supplied straight-edge, check the backfence alignment through machine.

Misalignment is the normat cause of inaccuracy issues

Étape 3 - Stainless Steel Bed

Use a suitable foam cleaner for cleaning off the glue and tape residue left by the profile rolling along the beds



Étape 4 - Saw Blade Area

Check saw blade teeth for wear or damage, check saw blade for warping

...When changing blade – ensure that the correct type and size saw blade is used, using the wrong type / size of blade can cause accuracy issues – Please refer to your Stuga manual for the correct specification of blade or contact Stuga Service for further assistance



Étape 5 - SZ Axis Saw Up / Down Drive

  • Check that the drive belt is free from wear or any cuts / nicks along the circumference of the belt
  • Ensure that the drive belt has sufficient tension via the tension roller
  • Check the leadscrew for any wear or damage
  • Grease with 1 Pump if lubricator not fitted



Étape 6 - Saw Tilt Rollers

...Only used if compound VS cut machine option
  • Check rollers and runner surface for damage or wear
  • Lightly oil rollers and runner surface


Étape 7 - SR Axis Slewing Ring and Pinion

  • Visually check pinion wheel and slewing ring for any damage, chips or cracks
  • Remove any debris that may have become caught up in the teeth
  • Turn assembly through full range of movement to check for any tight spots
  • Grease ring on grease points. 1 Pump each



Étape 8 - SY Axis Linear Rails

  • Lightly oil rail surface with supplied oil
  • Ensure reference sensor is not damaged
...There are 4 rails in total, 2 at front and 2 at rear


Étape 9 - Extraction Separator

Ensure that the Hose and Chute are not blocked by large offcuts

...Side open the Extraction separator base to empty offcuts

Check Hose for damage / cuts – replace if necessary



Commentaires

Draft