Autoflow Maintenance - Machining Centre

Auteur avatarGareth Green | Dernière modification 8/12/2022 par Gareth Green en cours de rédaction

Introduction

The Machine has many moving parts, all which need regular maintenance. Below outlines what items need particular attention:

Étape 1 - Infeed Clamp Vertical and horizontal rollers

  • Remove any tape or debris which may have become entangled in the rollers.
  • Apply oil to top and side of roller units and then slowly spin them for a few revolutions to allow the oil to penetrate the bearings
  • Lubricate slideways and shafts


Étape 2 - Spindle Motors

Ensure that each spindle will turn freely with no grinding noise when rotating, check cutters for chips or damage, check V – Notch blades for chipped or damaged teeth

Check Spindles slide freely in and out on full range of movement

Lubricate slideway bearings


Étape 3 - V Notch Axis Gearboxes

1 Pump Grease



Étape 4 - Slewing Ring and Pinion wheel

Visually check pinion wheel and slewing ring for any damage, chips or cracks, remove any debris that may have become caught up in the teeth



Étape 5 - R Axis Datum Assembly

Lubricate shafts and ensure smooth motion


Étape 6 - Y Axis Rails

4 off Located at the bottom of the machining centre cabinet.

Clean away any debris

Lightly oil rail surface with supplied oil



Étape 7 - Outfeed Clamp Vertical and Horizontal Rollers


  • Remove any tape or debris which may have become entangled in the rollers.
  • Apply oil to top and side of roller units and then slowly spin them for a few revolutions to allow the oil to penetrate the bearings
  • Lubricate slideways and shafts

Étape 8 - Z Axis Linear Bearings

4 off

1 – 2 pumps of grease via grease nipple, wipe away any excess grease

Étape 9 - Auto lube System

Check level of grease in Auto lube

Part replacement order code is M0001047



Commentaires

Draft