Ecoline - Disabling V axis To Swap Faulty Drive

How to disable the V axis on an Ecoline to utilise in place of a faulty drive

Difficulté

Hard Difficile

Durée

10 minute(s) minute(s)

Ecoline_Accuracy_Issues_sample_ecoline.gif

Introduction

If a drive fails on an Ecoline, the V axis can be utilised to enable the Ecoline to still run as a machining centre, albeit with V notching now disabled. This is a better situation than no machining at all, as all factories have V notching capability in addition to an Ecoline

Étape 1 - Backup the Original Project

Archiving a TwinCAT Project

Étape 2 - Take a copy of the axes.mul file

Étape 3 -

en none 0 Draft