Autoflow Maintenance - Sawing Centre

Procedures for Daily, Weekly and Monthly Maintenance on Autoflow Sawing Centre Module

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

Autoflow, Maintenance, Sawing Autoflow.jpg.jpg

Introduction

The Machine has many moving parts, all which need regular maintenance. Below outlines what items need particular attention

Étape 1 - Horizontal and Vertical clamps

• Remove any debris from clamp pads and rollers
• Visually check the rollers and clamp pads for damage or excessive wear, oil rollers with supplied oil, visually check cylinder rods for damage

Étape 2 - Check Rear Fence Alignment

Using the supplied straight-edge, check the backfence alignment through machine.

Misalignment is the normat cause of inaccuracy issues

Étape 3 - Stainless Steel Bed

Use a suitable foam cleaner for cleaning off the glue and tape residue left by the profile rolling along the beds

Étape 4 - Saw Blade Area

Check saw blade teeth for wear or damage, check saw blade for warping

...When changing blade – ensure that the correct type and size saw blade is used, using the wrong type / size of blade can cause accuracy issues – Please refer to your Stuga manual for the correct specification of blade or contact Stuga Service for further assistance

Étape 5 - SZ Axis Saw Up / Down Drive

• Check that the drive belt is free from wear or any cuts / nicks along the circumference of the belt
• Ensure that the drive belt has sufficient tension via the tension roller
• Check the leadscrew for any wear or damage
• Grease with 1 Pump if lubricator not fitted

Étape 6 - Saw Tilt Rollers

...Only used if compound VS cut machine option

• Check rollers and runner surface for damage or wear
• Lightly oil rollers and runner surface

Étape 7 - SR Axis Slewing Ring and Pinion

• Visually check pinion wheel and slewing ring for any damage, chips or cracks
• Remove any debris that may have become caught up in the teeth
• Turn assembly through full range of movement to check for any tight spots
• Grease ring on grease points. 1 Pump each

Étape 8 - SY Axis Linear Rails

• Lightly oil rail surface with supplied oil
• Ensure reference sensor is not damaged

...There are 4 rails in total, 2 at front and 2 at rear

Étape 9 - Extraction Separator

Ensure that the Hose and Chute are not blocked by large offcuts

...Side open the Extraction separator base to empty offcuts

Check Hose for damage / cuts – replace if necessary

en none 0 Draft