Autoflow Maintenance - Infeed

Weekly and Monthly Maintenance Procedures for Autoflow Infeed Table

Difficulté

Easy Facile

Durée

30 minute(s) minute(s)

Autoflow, Maintenance, Weekly, Monthly Autoflow.jpg.jpg

Introduction

The following preventative maintenance tasks should be carried out regularly on the machine. The frequency depends on the machine use, but as a guide:

2-3 Shifts        Weekly
40 Hrs/Week       Bi-Weekly
20 Hrs/Week       Monthly

Étape 1 - Stainless Steel Bed

Use a suitable foam cleaner for cleaning off the glue and tape residue left by the profile rolling along the beds

Étape 2 - Main display unit (Monitor)

Clean display with soft cloth to avoid dirt, etc. causing malfunction of the touch screen

Étape 3 - Rear Backfence Rollers

Apply oil to top and side of roller units and then slowly spin them for a few revolutions to allow the oil to penetrate the bearings

Étape 4 - Drive shafts

1 pumpsof grease via grease nipple, check for any signs of damage or wear

Étape 5 - Pop-Up function

Using the Service screen, check the pop up rows rise and sink in unison

Étape 6 - Flapper Paddles

Check function and operaton of each paddle - ensure it does not stick in up or down position

Étape 7 - End Stop

Ensure the end stop slides on the linear cylinder. The system acts under a low constant pressure and should slide easily

en none 0 Draft