500mm Saw Blade Upgrade
Difficulté
Moyen
Durée
4-6 heure(s)
Introduction
Step by step guide of how to carry out the 300mm to 500mm saw blade upgrade including long reach clamps.
Time to complete is very dependant on condition of the machine, ie rusted or rounded off bolts which may need to be drilled out and holes re-tapped.Avertissement des objets pointus et tranchants
Étape 1 - Remove Taper Lock Pulleys
Remove the two grub screws from the taper lock pulleys and insert one into the hole that was initially empty. Screw in tight to break seal of taperlock and split the two parts. If siezed the outer part can be tapped back with a hammer. These parts are usually very brittle and can shatter with a heavy hammer blow. It can also be useful to have the belts on at this point to stop the pulley from turning.
Draft
Français
English
Deutsch
Español
Italiano
Português