Procedures for Maintenance of the Autoflow Machining Centre Module
Difficulté
Moyen
Durée
2 heure(s)
Introduction
The Machine has many moving parts, all which need regular maintenance. Below outlines what items need particular attention:
Étape 1 - Infeed Vertical and horizontal rollers
Daily – remove any tape or debris which may have become entangled in the rollers
Weekly – apply oil to top and side of roller units and then slowly spin them for a few revolutions to allow the oil to penetrate the bearings
Étape 2 - Spindle Motors
Daily – Ensure that each spindle will turn freely with no grinding noise when rotating, check cutters for chips or damage, check V – Notch blades for chipped or damaged teeth
Check Spindles slide freely in and out on full range of movement
Monthly - Lubricate slideway bearings
Étape 3 - Slewing Ring and Pinion wheel
Daily – clean area of swarf or debris
Weekly – visually check pinion wheel and slewing ring for any damage, chips or cracks, remove any debris that may have become caught up in the teeth
Étape 4 - Y Axis Rails
4 off Located at the bottom of the machining centre cabinet.
Daily – clean away any debris
Monthly– lightly oil rail surface with supplied oil
Étape 5 - Z Axis Linear Bearings
4 off
Daily – clear area of debris
Monthly– 1 – 2 pumps of grease via grease nipple, wipe away any excess grease
Étape 6 - Auto lube System
Check level of grease in Auto lube
Part replacement order code is M0001047
Draft
Français
English
Deutsch
Español
Italiano
Português