Commissioning - Z-Block Calibration

Commonly used during sawing on Z transoms, the Z block operation is used to fasten the profile, making sure it does not move during sawing.

Difficulté

Medium Moyen

Durée

30 minute(s) minute(s)

Z-Block, Saw, Commissioning, commission, Z Transom

Introduction

Commonly used during sawing on Z transoms, the Z block operation is used to fasten the profile, making sure it does not move during sawing. There are 6 possible states the z block can be in. Each of these can have a different length of protrusion for different profiles.

12 x M8 Screws

12 x M8 Nuts

12 x wire numbers 1 - 6

Étape 1 -

Étape 2 -

en none 0 Draft