ACEpc Changing IP address using netedit

Using the netedit program to change the IP address of an ACEpc running DOS software

Difficulté

Easy Facile

Durée

5 minute(s) minute(s)

ACEpc, network, netedit Manual-ACEpc_ACEpclogo.jpg

Introduction

The ACEpcs use two different systems for connecting a network

1. NETBeui - this was used on earlier machines but reliability depends on the customer network setup. Reconfiguration after initial setup is difficult
2. IP addressing - A setup system was written using IP addresses to connect. This is a little harder to set up, but is easier to change later. A special program called netedit was written which updates all the correct files in the background

Étape 1 - Check if netedit is installed

At the command prompt, change to drive C: and ensure netedit exists

If the file does not exist, follow the procedure for installing the netedit software using a 'netsetgo' disk

https://stuga.dokit.app/wiki/ACEpc_Installing_netedit_with_NetSetGo_disk

Étape 2 -

en none 0 Draft