WinMulti - Datum Test

This page will describe how to perform a Datum Test

WinMulti_-_Preforming_a_Manual_Input_WinMulti_-_Preforming_a_Manual_Input_MI-SingleOperation_1_.jpg

The Datum test tab should Ideally be used before production EVERY day. This area is used to ensure once the machine has been initialized that all the routing axes are in the correct place. To use it effectively you need to understand the axes on the machine. The diagram below illustrates this.

Ring Axes

To run a datum test:-

1. Tap the Manual Input Button from the main screen.

2. Select the profile from the list (preferably large outer)

3. Select the datum prep from the operations list

4. Type in the length of the profile into the Length field (ideally 1500mm+)

5. Type in the position of the datum prep into the position field (at least 400mm from either end of the bar.

6. Tap on the Add Op button

7. Tap on the Enter Button, this will create a batch on the main screen, which can be cut in the normal manner.

Once this has been cut and prepped you should have your test profile with 4 x 10mm holes prepped, one on each face of the profile these should be measured carefully and the values entered into the screen below.

Datum Test Adjustment

The measurements are as follows

X Axis: Measure from the gripper end of the profile to the centre of the bottom 10mm hole this should measure the same as the figure that was typed into step 5 above, if different determine how far the hole needs moving toward or away from the gripper ends and enter this figure into the appropriate numeric edit box. Once this is done tap on the X Axis Save button.

Y,Z & R: for these you need to measure from the back of the profile to the back of the bottom hole and enter this figure into the Y Measurement of the bottom hole.

Measure from the bottom of the profile to the bottom of the front and rear holes and enter their values into the appropriate boxes.

Once this is done, tap on the Y/Z/R Axis Save Button.

After the datums have been modified tap on the Exit button and re prep the datum test on the same piece in a different position (usually the datum piece is kept for many days with each successive days test being 20mm further down the bar, in this manner a minimum of profile is used. From here you can see if the alterations made were successful.

en none 0

Draft