| [version en cours de rédaction] | [version en cours de rédaction] |
(Page créée avec « {{Tuto Details |Description=<translate>Checklist to overcome gripping accuracy issues on ZX5</translate> |Categories=Maintenance |Tags=ZX5, Accuracy, Gripper, Nose }} <tra... ») |
|||
| (Une révision intermédiaire par le même utilisateur non affichée) | |||
| Ligne 15 : | Ligne 15 : | ||
|Gripper Profile Present Lever slot length | |Gripper Profile Present Lever slot length | ||
D0015093 | D0015093 | ||
| − | | | + | |Slot length may need increasing to allow full range of travel |
| | | | ||
|- | |- | ||
| Ligne 21 : | Ligne 21 : | ||
|Gripper nose Dowels need to be +10mm longer fitted to a nose | |Gripper nose Dowels need to be +10mm longer fitted to a nose | ||
R0015004 Assembly drawing | R0015004 Assembly drawing | ||
| − | | | + | |Original design had 40mm dowels. Later upgraded to 50mm |
| + | <br /> | ||
| | | | ||
|- | |- | ||
|3 | |3 | ||
|Bolt that holds it needs a washer, not half nut | |Bolt that holds it needs a washer, not half nut | ||
| − | | | + | |Washers need to be fitted to get a positive grip |
| | | | ||
|- | |- | ||
| Ligne 36 : | Ligne 37 : | ||
|5 | |5 | ||
|Moving beam home and out sensor works on the last 0.5mm of travel | |Moving beam home and out sensor works on the last 0.5mm of travel | ||
| + | | | ||
| + | | | ||
| + | |- | ||
| + | |6 | ||
| + | |Clutch Tightness | ||
| + | | | ||
| + | | | ||
| + | |- | ||
| + | |7 | ||
| + | | | ||
| | | | ||
| | | | ||
|}</translate> | |}</translate> | ||
{{PageLang | {{PageLang | ||
| + | |Language=en | ||
|SourceLanguage=none | |SourceLanguage=none | ||
|IsTranslation=0 | |IsTranslation=0 | ||
| − | |||
}} | }} | ||
{{AddComments}} | {{AddComments}} | ||
Version actuelle datée du 17 mai 2021 à 18:42
Checklist to overcome gripping accuracy issues on ZX5
Sommaire
| Title | Notes | Picture | |
|---|---|---|---|
| 1 | Gripper Profile Present Lever slot length
D0015093 |
Slot length may need increasing to allow full range of travel | |
| 2 | Gripper nose Dowels need to be +10mm longer fitted to a nose
R0015004 Assembly drawing |
Original design had 40mm dowels. Later upgraded to 50mm
|
|
| 3 | Bolt that holds it needs a washer, not half nut | Washers need to be fitted to get a positive grip | |
| 4 | Backlash | ||
| 5 | Moving beam home and out sensor works on the last 0.5mm of travel | ||
| 6 | Clutch Tightness | ||
| 7 |
Draft
Français
English
Deutsch
Español
Italiano
Português