Commissioning - Off-Cut Laser Sensor

Setting up the laser sensors on the infeed of a Flowline, ZX4 and ZX5.

Difficulté

Easy Facile

Durée

10 minute(s) minute(s)

Laser Sensor, ZX4, ZX5, Flowline, Commissioning Commissioning_-_Off-Cut_Laser_Sensor_laser1.PNG

Introduction

Infeed Off-Cut Laser sensors are used to check the length of profile with the proposed length from the software. This is to avoid incorrect lengths and profiles being cut. The sensors will be put at specific lengths along the infeed which will be input in the software files. When profile hits the back fence all covered sensors will trigger, hence, the profile must be larger that the final triggered sensor.

Vimeo

Étape 1 -

en none 0 Draft