| [version en cours de rédaction] | [version en cours de rédaction] |
(Page créée avec « {{Tuto Details |Main_Picture=Commissioning_-_Off-Cut_Laser_Sensor_laser1.PNG |Main_Picture_annotation={"version":"2.4.6","objects":[{"type":"image","version":"2.4.6","orig... ») |
|||
| Ligne 14 : | Ligne 14 : | ||
{{TutoVideo | {{TutoVideo | ||
|VideoType=Vimeo | |VideoType=Vimeo | ||
| − | |VideoURLVimeo=https://vimeo.com/294109652/ | + | |VideoURLVimeo=<iframe src="https://player.vimeo.com/video/294109652" width="640" height="360" frameborder="0" allow="autoplay; fullscreen" allowfullscreen></iframe> |
}} | }} | ||
{{Materials}} | {{Materials}} | ||
| Ligne 24 : | Ligne 24 : | ||
{{Notes}} | {{Notes}} | ||
{{PageLang | {{PageLang | ||
| + | |Language=en | ||
|SourceLanguage=none | |SourceLanguage=none | ||
|IsTranslation=0 | |IsTranslation=0 | ||
| − | |||
}} | }} | ||
{{Tuto Status | {{Tuto Status | ||
|Complete=Draft | |Complete=Draft | ||
}} | }} | ||
Version du 3 octobre 2019 à 15:52
Setting up the laser sensors on the infeed of a Flowline, ZX4 and ZX5.
Difficulté
Facile
Durée
10 minute(s)
Introduction
Infeed Off-Cut Laser sensors are used to check the length of profile with the proposed length from the software. This is to avoid incorrect lengths and profiles being cut. The sensors will be put at specific lengths along the infeed which will be input in the software files. When profile hits the back fence all covered sensors will trigger, hence, the profile must be larger that the final triggered sensor.
Vimeo
Étape 1 -
Draft
Français
English
Deutsch
Español
Italiano
Português