Commissioning - Off-Cut Laser Sensor : Différence entre versions

[version en cours de rédaction]

Version actuelle datée du 21 août 2025 à 12:38

Setting up the laser sensors on the infeed of a Flowline, ZX4 and ZX5.

Difficulté

Facile

Durée

20 minute(s)

Setting up the laser sensors on the infeed of a Flowline, ZX4 and ZX5.

Difficulté

Facile

Durée

20 minute(s)

Confluence

21/08/2025 Moved to confluence

Vimeo

en none 0 Draft

@@ Ligne 5 : / Ligne 5 : @@
 |Categories=Maintenance
 |Difficulty=Easy
-|Duration=10
+|Duration=20
 |Duration-type=minute(s)
-|Tags=Laser Sensor, ZX4, ZX5, Flowline, Commissioning
+|Tags=Confluence
 }}
 {{Introduction
-|Introduction=<translate>Infeed Off-Cut Laser sensors are used to check the length of profile with the proposed length from the software. This is to avoid incorrect lengths and profiles being cut. The sensors will be put at specific lengths along the infeed which will be input in the software files. When profile hits the back fence all covered sensors will trigger, hence, the profile must be larger that the final triggered sensor.</translate>
+|Introduction=<translate>21/08/2025 Moved to confluence
+[https://stuga-ltd.atlassian.net/wiki/external/NWQyMzdiNGUxZjNlNGQ5NzhmZGY2YTQ3YTRiZDMzMDM Click here]</translate>
 }}
 {{TutoVideo
 |VideoType=Vimeo
-|VideoURLVimeo=https://vimeo.com/294109652/c84d27e9f4
+|VideoURLVimeo=https://vimeo.com/294109652
 }}
 {{Materials}}
@@ Ligne 24 : / Ligne 26 : @@
 {{Notes}}
 {{PageLang
+|Language=en
 |SourceLanguage=none
 |IsTranslation=0
-|Language=en
 }}
 {{Tuto Status
 |Complete=Draft
 }}