R0015318 Fit Swarf Chutes

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 1/11/2023 par Gareth Green en cours de rédaction

Introduction

Tools Required


Standard Hex key set

Pipe cutters


Parts Required

R0015084 Bench assemble and Drill Off Swarf chutes

Étape 1 - Unless otherwise stated

Use locktite 243 on all fasteners

Use loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised



Étape 2 - Fit lower chute lip

Fit lower swarf lip



Étape 3 - Fit side chutes

Fit 2 off side chutes


Do not finalise fasteners



Étape 4 - Fit swarf chute section one

Fit larger swarf chute section


Do not finalise fasteners



Étape 5 - Fit cylinder poscket

Fit cylinder pocket


Do not finalise fasteners



Étape 6 - Fit chute section 2

Fit chute section 2


Do not finalise fasteners



Étape 7 - Position for best fit

Position all sections in conjunction with each other for best fit



Étape 8 - Finalise all fasteners

Finalise all fasteners ensuring adhesive is applied



Étape 9 - Connect Chute blower feed pipes

Connect 2 off 6mm black air pipes to bulkheads for chute blowers on rear of swarf chutes



Étape 10 - Connect Y3501 and Y3502

Connect 3502 and 3501 6mm pipes to rear of chute and insert x63 reed switch through grommit



Étape 11 - Loom feed pipes to top clamp

Set position of reed switch on top clamp cylinder using test box


Loom and spiral wrap pipes and reed switch and restrain



Commentaires

Draft