R0015275 Fit shafts and pinions

instructions for installing main drive shafts to support arm assembly

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

R0015275_Fit_shafts_and_pinions_Screenshot_2023-07-06_114141.png

Introduction

Tools Required

Standard Hex key set

Parts Required

Previously assembled parts from R0015287 Bench Assemble Shafts, Bearings and Pinions

B0001100 x 12

B0001153 x 1

B0001165 x 1

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised

Étape 2 - Bearing position Clarification

1 Bearings should be located as shown on each arm

2 Grease nipples to face as shown

Étape 3 - Attach Bearings

1 Use 2 off M10 x 40 Countersunk bolts to centralise position of bearing block

2 Add 2 off M10 x 20 socket cap and fix in two holes indicated and tighten.

3 Replace M10 counter sunk bolts with another 2 off M10 x 20 socket caps

repeat for all bearing mounting positions

Étape 4 - Location of shafts

1 Shafts need to be correctly orientated

2 Each arm should have a key positioned as shown for drive pinions

Étape 5 - Fit shafts and pinions

^{Double check for dokit needed on this section. please take photos and gather ingformation please}

1 Shafts should be slid through bearing blocks to install. Drive pinions should be added to shaft between each arm as the shaft is fitted.

2 B0001165 1 off drive sprocket will also require adding to shaft as they are fitted . See images for location

3 B0001165 should be orientated as shown

...Do not fix any pinions into position, leave floating on shafts Do not fix any bearing grubscrew lock points

Étape 6 - Couple shafts

Couple shafts together with 1 off B0001153 shaft coupler and 2 off B0001100 key

Étape 7 - Fit keys

fit 10 off keys to relevant keyways and slide 9 drive pinions and 1 off drive sprockets into approximate positions

Étape 8 - Lubrication

all bearings should be lubricated with grease gun and trojan grease

en none 0 Draft