Instructions on mounting slider units to support arms
Difficulté
Moyen
Durée
1 heure(s)
Introduction
Tools Required
Standard spanner set
Parts Required
Étape 1 - Unless otherwise stated
Use Loctite 243 on all fasteners
Use Loctite 572 on all threaded pneumatic connections
Pen mark all bolts to show finalised
Étape 2 - Fit slider units to Arms
Slide pre built slider units on rails .
1 Ensure drive pinion is slid away from assembly
2 Use setting dokit Setting Delrin Transfer Table Wheel Tension and set delrin wheels to correct tension. Check at all points over oozenest V rail
3 Repeat for all 9 units
Étape 3 - Fit support arm spacers to arms
2 off per arm
Fix using M8 x 20 hex head Set bolt and finalise with loctite 243
Please provide pictures
Draft
Français
English
Deutsch
Español
Italiano
Português