R0015094 Fit shafts and Pinions

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 3/04/2024 par Gareth Green en cours de rédaction

Introduction

Tools Required


Standard Hex key set

Grease gun and grease


Parts Required


Previously assembled parts from R0015094 Bench Assemble shafts, Bearings and Pinions


B0001100 x 24

B0001153 x 2

B0001165 x 2

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised



Étape 2 - Bearing position Clarification

1 Bearings should be located as shown on each arm

2 Grease nipples to face each other as shown


Étape 3 - Attach Bearings

1 Use 2 off M10 x 40 Countersunk bolts to centralise position of bearing block


2 Add 2 off M10 x 20 socket cap and fix in two holes indicated and tighten.


3 Replace M10 counter sunk bolts with another 2 off M10 x 20 socket caps


repeat for all bearing mounting positions


Étape 4 - Location of shafts

1 Shafts need to be correctly orientated


2 Each arm should have a key positioned as shown for drive pinions




Étape 5 - Fit shafts and pinions

1 Shafts should be slid through bearing blocks to install. Drive pinions should be added to shaft between each arm as the shaft is fitted.

2 B0001165 2 off drive sprockets will also require adding to shafts as they are fitted . See images for location

3 B0001165 should be orientated as shown

...Do not fix any pinions into position, leave floating on shafts Do not fix any bearing grubscrew lock points

Étape 6 - Couple shafts

Couple shafts together with 1 off B0001153 shaft couplers and 2 off B0001100 key per shaft



Étape 7 - Fit keys

fit 20 off keys to relevant keyways and slide 18 drive pinions and 2 off drive sprockets into approximate positions



Étape 8 - Lubrication

all bearings should be lubricated with grease gun and trojan grease



Commentaires

Draft