How to convert a C0001292 Motor into a replacement for a Beckhoff C0001005 replacement
Difficulté
Difficile
Durée
30 minute(s)
Étape 1 - Supplied 3mm dowel with C0001200 encoder must be fitted to stepper motor
Étape 2 - Position of dowel
Mark the motor face as the picture to give the correct mounting position
A 3mm hole must be drilled in this position at a depth of 5mm . Caution, damage can be caused to motor if this depth is not adhered to. Increase drill sizes incrementally when drilling, to ensure a good sized 3mm hole
Use masking tape to stop swarf entering the stepper motor housing
Use a drop of Loctite 270 to ensure dowel remains in place when fitted
Étape 3 - C0001200 Encoder fitting
Add Loctite 243 to location clasp (pic 3) and refit to encoder.
Add Loctite 243 to 4 off grub screws in encoder collar
Fit encoder to stepper motor ensuring location clasp sits on top of fitted 3mm dowel.
ensure retaining collar with grub screw is against encoder face and then secure the 4 grub screws
Test rotation of stepper motor spindle to check correct running with encoder fitted
Étape 4 -
Draft
Français
English
Deutsch
Español
Italiano
Português