The Manual Saw Cuts tab is used for Autoflows and Microlines, where there is not a Saw screen separate from the Multihead Screen, On Autocut Saws, Flowlines, ZX3, 4 & 5, use the saw screen instead.
1. Order By
Select whether you want to Sort By Popularity or in Alphanumeric Order, then scroll down the list and select the profile you want to cut.
2. Length
Type in the length of the bar you wish to be added to the queue. This should be square cut at both ends.
3. Piece Length
Enter the length of the piece you want to cut from this profile.
4. End Prep
Click on the End Prep Required, the piece will then be added to the cutting list to the right, repeat steps 3 - 4 until all the pieces you wish to cut from this profile have been added to the list.
5. Clear All
If you have made a mistake with the pieces to be added to this profile, then click on this button to clear the piece list and add new pieces using Steps 3-4
6. Enter / Cancel
Once all the pieces to be cut have been added to the piece list, then click Enter and the profile will be added to the bar queue. If you instead wish to skip this bar, then click Cancel
ennone0
Commentaires
Draft
×
Erreur de saisie dans le nom du tutoriel
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #
Connexion
Pas encore enregistré ? Créez un compte pour profiter de toutes les fonctionnalités du service !