WinMulti - Drives

Auteur avatarStuga Engineer | Dernière modification 16/04/2020 par Stuga Engineer en cours de rédaction

Drives

The Drives tab allows manipulation of each of the axes. Each Machine type will have different drives as shown below. The manipulation of these can only be performed in Manual Mode, to enter manual mode from the main screen press the STOP Button once.

Saw Drives

Saw Drives
Autocut Drives
Drive Description
GX Axis This is the axis for the saw pusher and works from 7060 (end if the infeed bed) to 0 (Saw Blade)
SR Axis This is the axis for the Saw Blade Rotation and works from 45 to 135 degrees


Axes


+ / - Buttons

Once in Manual Mode tapping on the + and – buttons next to each of the drives will jog the axis in the appropriate direction, and the numbers between the +/- buttons show the current axis position.

Home

Tapping on the Home Button will move the axis back to its home position, as determined in the Settings – Axis screen.

Move & Stop

Type the position required into the Numbers after the Move button. When the move button is then pressed, the drive will attempt to move to the axis position given. Stop can be pressed at any point to halt this movement.

Reverse

The Reverse button reverses the direction of the associated drive.

Numbers

The Numbers after the Reverse button are (In order) Maximum Position, Speed, Acceleration, Deceleration


Speed Override

The speed override slider slows down the motor movements to give the operator time to intervene in diagnostic exercises.

Save

The Save Button saves and setting changes (e.g. Inverter frequencies)

Setup Mode

This puts the machine into setup mode.

Test Printer

This button sends a test label to the printer.

Ecoline

Ecoline Drives
Ecoline Drives
Drive Description
X Axis This is the Gripper axis along the bar and works from the end of the infeed bed to the centre of the tools on the Ring
Y Axis This is the Axis Away and Toward the operator and works from -104 to 119
Z Axis This is the Up and Down axis and works from -114 to 110
G Axis This is the Gripper Forward/Back Axis and works from 23mm from the back fence to 52mm from the back fence
V Axis This is the V Notch Module axis and works from 5 to 250 home position is around 128mm
R Axis This is the Ring Angle and works from 0 degrees to 359 degrees, at 90 degrees the tool is closest to the operator.


Flowline / ZX3 Drives

Flowline Drives


Flowline Drives
Drive Description
X Axis This is the Gripper axis along the bar and works from the end of the infeed bed to the centre of the tools on the Ring
Y Axis This is the Axis Away and Toward the operator and works from -120 to 120
Z Axis This is the Up and Down axis and works from -120 to 120
R Axis This is the Ring Angle and works from 0 degrees to 359 degrees, at 90 degrees the tool is closest to the operator.
G Axis This is the Gripper Forward/Back Axis and works from 22mm from the back fence to 72mm from the back fence
SX Axis This is the Saw Pusher X Axis and works from the end of the bed to the centre of the saw Blade (0 to -6645)


Microline

ZX4 Drives

ZX5 Drives


ZX5 Drives


Autoflow Drives

Autoflow Drives



to return to the main page, please click WinMulti Software Operating Guide





Commentaires

Draft