This tutorial will provide a step by step guide on how to upgrade a ZX style machine to have Beckhoff drives and control system.
Difficulté
Très difficile
Durée
5 jour(s)
Sommaire
- 1 Introduction
- 2 Étape 1 - Preparation (Base)
- 3 Étape 2 - First Fix Servo Cabinet
- 4 Étape 3 - Preperation (On-Site)
- 5 Étape 4 - Remove Components - MH (Electrical)
- 6 Étape 5 - Remove Components - Saw (Electrical)
- 7 Étape 6 - Remove Components - Saw Infeed (Electrical
- 8 Étape 7 - Remove Components - Field Components
- 9 Étape 8 - Fit Parts - MH (Electrical)
- 10 Étape 9 - Fit Parts - Saw (Electrical)
- 11 Étape 10 - Fit Parts - Transfer (Electrical)
- 12 Étape 11 - Fit Servo Cabinet
- 13 Étape 12 - Wiring Cabinets
- 14 Étape 13 - Run Machine Cabling
- 15 Étape 14 - Upgrade Console - MH
- 16 Étape 15 - Upgrade Console - Saw
- 17 Étape 16 - Terminate Machine Wiring
- 18 Étape 17 - Tidying and Checks
- 19 Commentaires
Introduction
The ZX3 and ZX4 machines that have control systems that pre-date the Beckhoff hardware now have an upgrade available. The upgrade will bring up-to-date hardware to the machines control system and drives. The control system and drives will be changed to Beckhoff. TwinCAT 3 PLC and AX8000 series drives.
Attention
Consulter le manuel d'instructions
Utiliser des chaussures de protection
Pour l'entretien, débranchez l'appareil du secteur
Avertissement générique
Haute Tension
Étape 1 - Preparation (Base)
Check through all parts lists and make sure that the parts that have been requested are the parts that are in the box. The picked parts should include all the consumable products that are in the BoMs (bolts, tie wraps, wires etc).
Once parts have been checked, they need to be handed to production for pre-assembly.
Ensure all information and drawing packs are available in the service job and in the relevant technical information boards on Monday.com. Link to Monday board for drawing packs here:
Étape 2 - First Fix Servo Cabinet
Étape 3 - Preperation (On-Site)
Étape 4 - Remove Components - MH (Electrical)
Étape 5 - Remove Components - Saw (Electrical)
Étape 6 - Remove Components - Saw Infeed (Electrical
Étape 7 - Remove Components - Field Components
Touchscreens
Cabling
Étape 8 - Fit Parts - MH (Electrical)
Étape 9 - Fit Parts - Saw (Electrical)
Étape 10 - Fit Parts - Transfer (Electrical)
Étape 11 - Fit Servo Cabinet
Étape 12 - Wiring Cabinets
Refer to drawings
Étape 13 - Run Machine Cabling
Étape 14 - Upgrade Console - MH
Étape 15 - Upgrade Console - Saw
Étape 16 - Terminate Machine Wiring
Étape 17 - Tidying and Checks
Draft
Français
English
Deutsch
Español
Italiano
Português