| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 20 : | Ligne 20 : | ||
|Step_Content=<translate></translate> | |Step_Content=<translate></translate> | ||
|Step_Picture_00=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_Flowline_Ultrasonic_1_-_Copy.jpg | |Step_Picture_00=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_Flowline_Ultrasonic_1_-_Copy.jpg | ||
| + | |Step_Picture_01=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4469.JPG | ||
| + | |Step_Picture_02=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4476.JPG | ||
}} | }} | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Wiring</translate> | |Step_Title=<translate>Wiring</translate> | ||
|Step_Content=<translate>The sensor wiring directly replaces the 3 other sensors</translate> | |Step_Content=<translate>The sensor wiring directly replaces the 3 other sensors</translate> | ||
| + | |Step_Picture_00=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4473.JPG | ||
| + | |Step_Picture_01=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4474.JPG | ||
}} | }} | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Blower</translate> | |Step_Title=<translate>Blower</translate> | ||
|Step_Content=<translate>The blower should Tee in to the blower already there for the other offcut measurement sensors</translate> | |Step_Content=<translate>The blower should Tee in to the blower already there for the other offcut measurement sensors</translate> | ||
| + | |Step_Picture_00=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4478.JPG | ||
| + | |Step_Picture_01=Upgrade_Flowline_Opto_Sensors_to_Ultrasonic_IMG_4479.JPG | ||
}} | }} | ||
{{Notes}} | {{Notes}} | ||
Version du 9 septembre 2019 à 14:26
Upgrading the 3 off opto sensors on a flowline Mk3 infeed table to ultrasonic version
Difficulté
Moyen
Durée
2 heure(s)
Introduction
With the development of full colour ranges for profiles, the older flowline opto sensors often have trouble "seeing" the darker profiles. An upgrade kit is available (R0019014) to replace the optical sensors with an ultrasonic version
Étape 1 - Kit of Parts
Étape 2 - Mechanical Fitting
Étape 3 - Wiring
The sensor wiring directly replaces the 3 other sensors
Étape 4 - Blower
The blower should Tee in to the blower already there for the other offcut measurement sensors
Draft
Français
English
Deutsch
Español
Italiano
Português