Setting Profile Detection Laser Sensor

Auteur avatarGareth Green | Dernière modification 13/11/2019 par Gareth Green en cours de rédaction

Setting the laser sensor used on Flowline / ZX offcut sensors and Autoflow measurement sensors

Introduction

Setting the profile sensor correctly is important as it will lead to incorrect offcut measurement.

...It is especially important to ensure the sensor is set for the range of different colours

Video d'introduction

Étape 1 - Set up Dark / Light setting

...Incorrect L/D setting will make the sensor read back to front
  1. Turn L/D adjustment clockwise so it is on its maximum "L"
  2. Turn anticlockwise until Yellow light comes on
  3. Turn clockwise until Yellow light goes off



Étape 2 - Set the Sensitivity

Set range to 80-100mm using your hand or a piece of profile.

  1. Place the object to sense at the "just off" position
  2. Adjust sensitivity clockwise until Yellow light goes off
  3. Check by moving the bar into "just on" position



Commentaires

Draft