Fitment guide for Datum rollers
Difficulté
Moyen
Durée
1 heure(s)
Introduction
Tools Required
Standard hex key set
Parts Required
Étape 1 - Unless otherwise stated
Use locktite 243 on all fasteners
Use loctite 572 on all threaded pneumatic connection
Pen mark all fasteners to show finalised
Étape 2 - Mount Mid roller Assembly
Fit mid roller assembly as shown . Do not use adhesive at this stage .
Secure with 2 off M6 x 25 socket caps
Ensure indicated face is butted correctly
Étape 3 - Attach rear frame
Attach frame to rear as shown , secure with 6 off M10 x 30 socket caps and a form washers
Fit 8 off M8 x 12 flat bottom grubscrews as indicated
Do not use adhesive at this point
Check orientation as shown
Étape 4 - Attach roller assembly
Attach Roller assembly as shown , using 2 off M6 x 50 socket caps and A form washers
Do not use adhesive at this point
Draft
Français
English
Deutsch
Español
Italiano
Português