Fitting R0019199 Upgrade: Autoflow Slewing Ring Guard Kit

Kit R0019199 contains a kit of components for protecting the SR axis bearing system on an Autoflow. This area is prone to collect offcuts which can pull the seal from the SR axis bearing

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

Fitting_Autoflow_SR_Axis_Cover_Plates_SR_axis.jpg

Introduction

This area is prone to collect sharp - cornered offcuts which can pull the seal from the SR axis bearing

Étape 1 - Fit the mount blocks in the T section

Fit

4 off M0001050 M6 Mount block as shown

4 off F0000529 T Nuts

4 off F0000013 M6x16 Cap Screws

Étape 2 - Add Low Friction tape

The tape is to provide a sliding surface for the cover to slide over the aluminium plate below

Cut into 6 strips to fit between the bolt holes in the plate making a rough hexagon shape

Étape 3 - Mount Guard Plates

Mount the guard plates

1 off D0016081

1 off D0016082

On the Mount blocks using

4 off F0000012 M6x20 Cap Head

4 off F0000058 M6 Washer

en none 0 Draft