R0015093 Bench Assemble Transfer Beam

Bench assembly details for correct assembly of transfer rails

Difficulté

Medium Moyen

Durée

5 hour(s) heure(s)

R0015093_Bench_Assemble_Transfer_Beam_Screenshot_2023-09-20_080950.png

Introduction

Tools Required

Standard Hex key set

Standard hand taps

V rail alignment Jigs

Parts Required

B0001155 OpenRail 1000mm Long x 32

B0001170 spacer x 320

D0015571 Transfer Arm (2018) x 9

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 570 on all threaded pneumatic connections

Pen mark all bolts when finalised

Étape 2 - Transfer beam preparation

1 Remove all protective plastic wrap from D0015571 Transfer Arm (2018)

2 Tap all holes to clear debris.

3 Check area shown for sharp edges burrs. If present, dress down and report as rework.

4 Clean with air to remove swarf and debris

5 Wipe transfer beams with duck oil on a clean rag

Étape 3 - Fit V alignment jigs

Fit 4 off alignment jigs as shown, using jig fasteners

Étape 4 - Align spacers

Align 20 off B0001170 spacer over fixing holes as shown

Étape 5 - Prepare Rail

Each V rail contains 2 off B0001155 OpenRail 1000mm Long

Clean and align 2 off as shown to create One double V rail

en none 0 Draft