Move SR Datum Sensor to Higher Level R0019217

Moving the SR axis datum sensor to a higher level to prevent damage and improve reliability Autoflow Mk4 only

Difficulté

Hard Difficile

Durée

2 hour(s) heure(s)

Move_SR_Datum_Sensor_to_Higher_Level_R0019217_R0019217.JPG

Introduction

On a Mk4 Autoflow, The SR axis daum sensor is originally located at the rear and to the base of the SR axis. This area is prone to offcuts, so a new location has been designed at the top, with the following design parameters

• Easy to retrofit
• Sensor is protected in a case
• Short distance to connection box
• Uses existing mounting holes
• Easy to adjust and maintain
• Sensing end location should be vertical onto a plate, not horizontal on to a radiused surface
• Can use E0000336 2mm range sensor reliably

The parts are supplied in Kit R0019217

...The pictures and models illustrated here are from a Right to Left feed machine. Parts are unhanded so can be fitted to either hand machine

Étape 1 - Fit Replacement SR Detection bracket

Replace the upper brace plate with D0016338. This has the detection plate for the SR axis added on the top

Étape 2 - Assemble Sensor Cable and Holder

1. Assemble the cable using E0001046 cable plus E0001069
2. Add E0000336, and assemble in to D0016341 Autoflow SR Sensor holder
3. The sensor (with fastening nut) should protrude 5mm from base of holder

Étape 3 - Fit Sensor holder to Side Clamp

The sensor holder fits on existing holes that mount thee saw infeed side clamp

Étape 4 - Fit wire

Sensor Cable fits to the etherCAT box as pictured

en none 0 Draft