Align and pin main rack on Stuertz infeed
Auteur Gareth Green | Dernière modification 29/09/2023 par Gareth Green en cours de rédaction ⧼frevu-button-review-label⧽
Pas encore d'image
Align and pin main rack on Stuertz infeed
The rack on a Stuertz infeed is a helical type and is supplied unpinned, as the motor is not connected before delivery to Stuga
The alignment must be checked then dowelled with 5mm roll pins
Using the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour
Use F0000281 (5mmx 16mm roll pin)
Drill the steel below to a depth of 8mm
Knock in the dowel to secure
en none 0 Draft
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #