Stuertz Infeed - Align and dowel GX rack

Align and pin main rack on Stuertz infeed

Difficulté

Hard Difficile

Durée

2 hour(s) heure(s)

Introduction

The rack on a Stuertz infeed is a helical type and is supplied unpinned, as the motor is not connected before delivery to Stuga

The alignment must be checked then dowelled with 5mm roll pins

Étape 1 - Align with T0001090 Tool

Using the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour

Étape 2 - Run GX up and down to ensure it is smooth

Étape 3 - Dowel each rack one end with a 5mm roll pin

Use F

en none 0 Draft