Omron E5CVS PV Shift

The Purpose of the PV Shift is to make the temp controller as accurate as you can to the plate temperature.

Difficulté

Easy Facile

Durée

10 minute(s) minute(s)

Introduction

Utiliser des vêtements de protection pour les mains

Avertissement pour surface chaude

Étape 1 - Unit Operation

Using the Mode switch step through until you reach

Étape 2 - Checking if Input shift is ON.

Étape 3 - Adjust Shift value until Temperature at Plate is same as on Display

H0 = No offset. Temp at Plate =230 degrees - Display on E5CSV = 240 Degrees

L10 = - 10 degree. Temp at plate = 230 degrees - Display E5CSV = 230 Degrees

H10 = +10 degree . Temp at plate = 230 degrees - Display E5CSV = 250 Degrees

Étape 4 - Checking Protection button is not locked. Dip Switch P

en none 0 Draft