R0015267 Assemble Backfences, Fit and Align

Auteur avatarGareth Green | Dernière modification 22/11/2023 par Gareth Green en cours de rédaction

Introduction

Tools Required


Standard Hex Key set

Wire Line

150mm Rule


Parts Required


D0015420 M/C Infeed Backfence Plate x 9

D0015468 Infeed Backfence Bracket x 9


Étape 1 - unless otherwise stated

All bolts to have Loctite 243 adhesive applied unless otherwise stated

All Threaded Pneumatic connections to have Loctite 570 applied

All bolts to be pen marked once adhesive applied and correct tension added



Étape 2 - Assemble backfences

1 Mount D0015420 M/C Infeed Backfence Plate to D0015468 Infeed Backfence Bracket as shown


2 position at middle slot as shown


Use 2 off M6 x 12 Socket cap and A form washers to fix parts together


Do not add adhesive at this stage


Étape 3 - Mount backfences to frame

1 Mount assembled backfences to frame in position shown on each loader arm

(parts removed for clarity )


Use M6 x 16 Socket caps with m6 penny washers to fix


2 Set height to be as shown


3 Ensure back fence is vertical and at 90 degrees to green runner strip


Étape 4 - Retract middle positions of backfences

1 retract indicated backfences in the direction shown to maxuimum movement in slot


2 Check positions shown are middle slot



Étape 5 - Wire line setting

Use dokit Alignment guide using wire line for correct process


Set wire line between 1st and last backfence and adjust middle 7 to correct position


Once aligned , add adhesive to all bolts one at a time


Check that no movement occurs when finalising fixings

Commentaires

Draft