Toshiba - B-EX4T1 Printer Setup

B-EX4T1 Printer Setup for Auto Labeling

Difficulté

Easy Facile

Durée

20 minute(s) minute(s)

B-EX4T1, Toshiba Toshiba_-_B-EX4T1_Printer_Setup_Toshiba_TEC_-_B-EX4T1_Series_-_1.jpg

Étape 1 - Inner & Outter

The instructions for the both Inner & Outter wound labels are on the inside of the open lid.

Étape 2 - Rewind Spool

There will be no ribbon and as the seetings will be for Peel Off a length of blank backing needs to be feed onto the Rewind spool

Étape 3 - Printhead access

To gain access turn the green knob to FREE. You can then pull the front plate down and lift the printer head up.

Étape 4 - Setting Rewinder

Ensure the Switch is set to REWINDER

Étape 5 - Label Guides

With the Printhead open ensure that the labels are under the small black sprung guids. Slide the green gluide to the width of the label.

Étape 6 - Sensor Position

Ensure that the send head is in the middle of the label

Étape 7 - Closing Label Head

When Loaded close the Printhead down, lift the front plate up and turn the green knob to LABEL.

Étape 8 - Connecting printer to PC

For easy setup use a USB cable (Everything can be done via the network web interface)

1) Connect a USB cable to the PC

2) Connect a Network cable to a live DHCP network to obtain an Ip address.

3) Download load the BCP setup software: https://www.toshibatec.com/download_overseas/printer/setting_tool/BCP_Series/ [1]

Étape 9 - Initial Power up

If the labels have been fitted properly on power up the calibration process will eject several labels.

Take a note of the IP addres given to the printer on the front panel.

Étape 10 - Using BCP to setup the printer

When you start BCP you should see.

Select USB if not Selected

Étape 11 - Change Settings

Press the Emulation Button and take the top option "Zmode System Parameters Settings"

Then Make the changes

• Label Length 38mm (after calibration this will be reset to 41.3)
• Label Width 98mm
• Ribbon WITHOUT RIBBON
• Print mode PEEL OFF
• Sendor TRANS PREPRINT
• Max Label Length (for callabration) 200mm (this just saves on the callorbration)

Press the DOWNLOAD button and check that there are no errors.

Étape 12 - Testng

1) Pressing Feed should push out another label regards.

2) Send a lable to the printer via the network (or via the Test - Send file within BCP).

3) Send more that one file and make sure that eah time you remove a label fomr the output the ext one is presented.

Étape 13 - Set IP for the Customers network

en none 0 Draft